J1

Aftermarket/Option Parts


Inserting the small inner bearing and bushings were the first step I took for J1. Make sure the bearing is fully seated, it's a tight fit.

Install the c-hub with the steering arm opposite the Team Durango logo on the caster block.

The DEX410 uses the smaller 14mm hex included on the parts trees.

Don't forget to insert the crush spacer before installing the outer bearing. Use a bit of thread lock on the hex pin to prevent it from falling out.


J2

Aftermarket/Option Parts


A simple step, make sure that the inner bearing is full seated, it's a tight fit. Don't forget the crush spacer and apply a bit of thread lock to the hex pin. Make sure you install the ball stud on the correct side too.

<< PrevNext >>